Disclaimer: You are free to reuse it “as-is”, on your own responsibility and without any guarantee whatsoever. No rights can be derived from, successfully or unsuccessfully, completing the steps outlined below.
It connect the shape like this:
A list of known issues. Implementations not listed here may or may not work as expected. Results may vary depending on user settings and computer environment. Use at your own risk.
The example document doesn't set the draw:start-glue-point attribute Both results are valid within ODF 1.1 - 9.2.9 Connector:
If this attribute is not set and the start of the connector is connected to a shape, the application may choose the glue point. If the start of the connector is not connected to a shape, this attribute is ignored.